Publicidad
Idiomas disponibles
Idiomas disponibles
45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
finish 0° bevel angle adjustment.
1.
Tighten the thumb screw to secure the carriage.
2.
Loosen the lever. Then fully tilt the carriage to the
left.
2
1
Fig.57
► 1. Thumb screw 2. Lever
3.
Check if the pointer indicates the 45° position in
the bevel angle scale.
If the pointer does not indicate the 45° position, align it
with 45° position by turning the 45° adjusting bolt.
1
Fig.58
► 1. 45° adjusting bolt
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.59
► 1. Limit mark
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.60
► 1. Brush holder cap
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 min-
utes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
the electric brake is not working correctly, have the tool
repaired by a Makita service center.
After use
After use, wipe off chips and dust adhering to the tool
with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled "Blade guard". Lubricate the sliding por-
tions with machine oil to prevent rust.
28
ENGLISH
1
1
Publicidad
