Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
If else fault code "F04" to "F98" is shown
Electronic module fails.
Turn the nub to Off for 3 seconds to turn off the machine.
After fault is removed, press "Start/Pause" key. If fault occurs again, disconnect power supply
and contact with after-sale service.
If fault code "Unb" is shown
Unbalance alarm shall be solved by the following methods.
1.
Laundry winding
Turn the knob to "off" for 3 seconds for shutdown, open the door, shake the clothes and put
them back into the washing machine, then select the single dewatering program to dry again.
2.
Too light-weighted laundry
Turn the knob to "off" for 3 seconds for shutdown, open the door, put in one or two towels,
and then select the single dewatering program to dry again.
Before contacting After-Sales Service:
1.
Try to remedy the problem yourself (see "Troubleshooting Guide").
2.
Restart the programme to check whether the problem has solved itself.
3.
If the washing machine continues to function incorrectly, call After-Sales Service.
Transport/handing
Never lift the appliance by the worktop when transporting.
1.
Pull out the mains plug.
2.
Turn off the tap.
3.
Disconnect the inlet and drain hoses.
4.
Eliminate all water from the hoses and from the appliance (see "Removing the Filter",
"Draining Residual Water").
5.
Fit the transport bolts (obligatory).
6.
The machine is over 55 kg in weight, two persons are needed to move it.
29
EN
Publicidad
