Descargar Imprimir esta página

Bosch PS22BN Instrucciones De Funcionamiento Y Seguridad página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

2610031969 09-13_2610031969 09-13.qxp 10/3/13 10:50 AM Page 10
4X BIT TIP HOLDER
Store only bit tips in the on-
W RNING
tool bit holder. Longer bits
could interfere with proper tool operation and
result in user injury.
The four piece bit tip holder can be used for
convenient on tool storage of your most
commonly used bits. The bit tip holder can be
BELT CLIP
PROTECTION AGAINST DEEP
DISCHARGING
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty,
the tool is switched off by means of a
protective circuit.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
FORWARD/REVERSING
LEVER & TRIGGER LOCK
After tool use, lock trigger
W RNING
in "OFF" position to help
prevent accidental starts and accidental
discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 7). This lever was designed
for changing rotation of the bit, and for locking
the trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
Do not change direction of
C UTION
rotation until the tool
used on its own, or in conjunction with the belt
clip accessory. If mounting both the belt clip and
bit holder accessory, be sure to place the belt
clip accessory between the bit tip holder
accessory and the tool. Always make sure you
securely tighten the mounting screw before use.
(Fig. 6).
FIG. 5
Operating Instructions
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed (Fig. 1).
When the trigger switch is released it activates
the brake to stop the chuck quickly. This is
especially useful in the repetitive driving and
removal of screws.
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
-10-
FIG. 6
BIT
HOLDER
BRAKE
FIG. 7

Publicidad

loading

Este manual también es adecuado para:

Ps22Ps32Ps32-02Ps31-2a