Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Troubleshooting tips
Before Calling For Service
Reviewing the charts on the following pages may save you from calling for service.
Problem
Dishwasher
doesn't start
Water not pumped
form dishwasher
Foam in the tub
Stained tub interior
Possible Causes
• Fuse blown, or
the circuit break
tripped.
• Power supply is not
turned on.
• Water pressure is
low
• Door of dishwasher
not properly closed.
• Twisted or trapped
drain hose.
• Filter clogged.
• Kitchen sink
clogged.
• Wrong detergent.
• Spilled rinse aid.
• Detergent with
colourant may have
been used.
39
What To Do
• Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
• Make sure the dishwasher is turned
on and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
• Check that the water supply is
connected properly and the water is
turned on.
• Make sure to close the door properly
and latch it.
• Check the drain hose.
• Check the filter system.
• Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining ,
you may need a plumber rather than
a serviceman for dishwashers.
• Use only the special dishwasher
detergent to avoid suds. If this
occurs, open the dishwasher and
let suds evaporate. Add 1 liter of
cold water to the bottom of the
dishwasher.
Close the dishwasher door, then select
any cycle. Initially, the dishwasher will
drain out the water. Open the door after
draining stage is complete and check
if the suds have disappeared.
Repeat if necessary.
• Always wipe up rinse aid spills
immediately.
• Make sure that the detergent has no
colourant.
EN
Publicidad
