Publicidad
Idiomas disponibles
Idiomas disponibles
Timer
During operation the timer will count-up from
zero to display the accumulated processing
time. Continuous operation will stop if the
timer reaches 20 minutes (19:59) and the unit
will return to standby mode.
To control the processing duration – press
the up or down arrows to set the timer for any
recipe that requires a specific length of time
the ingredients should be processed. Each
single press will adjust by 5 seconds, holding
the button will adjust in 10 second or higher
increments. The TIMER icon will be displayed
on the screen.
Press PLAY | PAUSE to initiate processing
and the unit will operate as the displayed time
counts down. The motor will run continuously
until the timer reaches zero. Removing the
large pusher or using the pause function will
not affect the set time during processing.
Pressing POWER or PULSE buttons during
operation will clear the timer and return to
standby.
After Processing
Wait until the blades or disks have stopped
moving before unlocking the lid. Ensure that
the unit has been turned off using the POWER
button and unplug at the power outlet before
handling the blades or disks.
When removing the blades or disks, lift the
part by carefully gripping the plastic hub area
in the center.
Overload Protection System
The food processor has an overload protection
system to prevent damage to the motor – this
will cause the food processor to go into standby
mode and the OVERLOAD PROTECTION
icon will flash.
Unplug the food processor and allow to cool for
30 minutes.
If the blades or disks stall while processing,
immediately stop the machine, then unplug
from the power outlet before clearing the
wedged ingredients. If this happens more
than once, the bowl may be overloaded. Try
processing in smaller batches.
EN
17
Publicidad
