Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling feet
To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to compensate for the uneven floor.
The front should be slightly higher than the rear to aid in door closing.
Leveling screws can be turned easily by tipping the cabinet slightly.
Turn the leveling screws counterclockwise
lower it.
Moving the appliance
1. Before the refrigerator is moved,take all objects inside out,pull the power
plug out.
2. Fix the glass partitions,vegetable holder,freezing chamber drawers and ect.
with tape,and tighten the leveling feet;close the doors and seal them with tape.
3. Move the appliance with more than two people carefully. During moving,the
appliance shall not be excessively laid upside down or horizontally,or be
vibrated;the inclination during movement shall be no more than 45° .
4. After installing the appliance, connect the power plug into a socket out to
switch on the appliance.
ATTENTION
Precautions before operation:
Before making changes the refrigerator must be disconnected from power.
precautions should be taken to prevent any personal injury.
Placement
• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the refrigerator; tear off the protective film on the doors and the
refrigerator body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the refrigerator; do not put the refrigerator in moist places
easy to be splashed with water so as not to affect the electrical insulation properties
of the refrigerator.
• The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat,
and sturdy (rotate left or right to adjust the wheel for leveling if unstable).
to raise the unit, clockwise
06
to
EN
Publicidad
