Kärcher CVS 65/1 Bp Pack Manual Del Usuario página 5

Initial startup
Adjusting the push handle
Note
When the device is delivered, the push handle is folded down. It
can be adjusted to 3 different heights for work.
1. Fold the push handle up into the desired position. Make sure
that the grooves engage correctly in the bolts (fixation).
2. Tighten the star screws hand-tight.
Opening/closing the cover
CAUTION
Danger of crushing if your fingers are jammed
To open and close the device cover, only grasp the recessed grip
provided.
ATTENTION
Risk of burns from the hot drive motor
The drive motor can get hot during operation.
Do not touch hot surfaces. Pay attention to the warning symbols.
Note
It is necessary to open the cover:
● for service and cleaning work
● for changing/cleaning the dust filter and pre-filter
● for storing a replacement battery.
1. Open the cover: Grab the cover by the recessed grip and slow-
ly swivel it all the way forward. A strap holds the cover.
2. Closing the cover: Slowly swivel the cover back.
Mount the side brush
The side brush is supplied with the device and must be attached
to the device before initial startup.
See chapter "Changing the side brush".
Charge/insert battery
Charge the battery before initial startup.
A description of this can be found in the separate operating in-
structions for the battery and charger.
1 Insert the charged battery into the battery holder, slide it in as
far as it will go and click into place.
Notes on sweeping operations
CAUTION
Risk of damage
Carry out cleaning work in the forward direction of travel.
Do not carry out any cleaning work with the waste container re-
moved.
Do not let the device run in place with the roller brush switched
on.
Do not sweep in packing tape, string or the like (damage to the
sweeping mechanism).
Note
Adjust the sweeping speed to the conditions in order to get an op-
timal cleaning result.
Sweeping with a roller brush and side brush
On/Off switch
1
Adjusting the contact pressure of the roller brush (twist grip)
2
Roller brush contact pressure display
3
– LED does not light up: Lower the roller brush further
– Green LED: correct adjustment
– Red LED: Raise the roller brush
Lower side brush
4
Side brush adjustment
5
– Adjust contact pressure
– Raise side brush
1. Switch on the device with the On/Off switch (position I).
a Roller brush and side brush rotate.
2. Push the device forward on the push handle and start clean-
ing. Use the roller brush contact pressure adjustment in accor-
dance with the textile pile.
a To adjust, lift the twist grip, then turn.
b The correct contact pressure is indicated by a green LED.
3. For cleaning close to the edge, lower the side brush by press-
ing the side brush lowering button.
a If necessary, use the side brush adjustment and set the con-
tact pressure.
4. To pick up larger objects (20 mm), push the push handle down
a little so the roller brush can move the objects into the waste
container.
5. An automatic cleaning of the pre-filter ensures continuous
work.
6. Always recharge the battery in good time.
a During the sweeping operation, the display in the battery
shows the remaining time in minutes.
b When the device is switched off, the battery charge is dis-
played in %.
English
Operation
5