Kärcher CVS 65/1 Bp Pack Manual Del Usuario página 8

8. Place the new roller brush on the drive pin (left). On the oppo-
site side, engage the bearing shell in the bore of the roller
brush arm.
9. When the device is tilted, check the setting of the front sealing
strip, readjust if necessary.
Change/adjust sealing strips
Sealing strips
Side sealing strips
Front sealing strip
Rear sealing strip
Front sealing strip
1
Side sealing strip
2
Rear sealing strip (not adjustable)
3
Attachment
4
Waste container
5
1. Loosen the attachment of the sealing strips.
2. Adjust the sealing strip by sliding it in the elongated holes.
a See the table for values.
3. If the adjustments are correct, fasten the sealing strips.
8
Adjustment values
Distance to the floor 0.039 -
0.078 in (1 - 2 mm)
Distance between sealing strip
and retaining plate 1.18 in (30
mm)
Not adjustable
Troubleshooting guide
Note
Contact customer service for all malfunctions not listed!
Roller brush / side brush do not run or run incorrectly
 Turn on the On/Off switch (position I).
 Charge the battery.
 Engage the battery correctly.
 The electronics switched off the device due to an overload
(LED flashes). Observe when switching on again:
a Switch off the device using the On/Off switch.
b Raise the roller brush by lifting the twist grip and turning it all
the way up in an counterclockwise direction.
c Switch on the device using the "On/Off switch".
 Check roller brush / side brush for wrapped straps.
 Check the belt.
 Fully close the cover (cover switch).
Dust when sweeping / insufficient suction
 Empty the waste container.
 Check/replace the seals on the filter box and waste container.
 Check / clean / replace dust filter and pre-filter.
a Check that the dust filter and pre-filter are fitted correctly.
b Clean the dust filter and pre-filter if they are lightly contami-
nated.
c Replace the dust filter and pre-filter if they are damaged or
highly contaminated.
 Check / adjust / replace the sealing strips for wear and tear.
 Blower defective, contact customer service.
Sweeping performance not satisfactory
 Correctly adjust the sweeping level of the roller brush and side
brush using the adjustment option.
 The roller brush and side brush are too worn out, replace
them.
 Check the sealing strips for wear and tear, adjust / replace if
necessary.
Accessories/spare parts
Below (extracts) is an overview of wear parts or optionally avail-
able accessories.
Accessories
Side brushes
Roller brush
Dust filter
Pre-filter
Replacement battery
'Battery Power+ 36/
75 DW'
"Battery Power +"
charger
English
performance
Description
For interior textile coverings 5.032-221.0
For interior textile coverings 4.762-642.0
Flat filter (HEPA)
High-performance battery
36 V, 7.5 Ah * CUL
Quick charger 36 V * CUL
Order no.
6.907-776.0
5.745-280.0
2.445-075.0
2.445-053.0