Kärcher CVS 65/1 Bp Pack Manual Del Usuario página 7

Maintenance work
Clean/change the dust filter
DANGER
Health risk from dust
Wear a dust mask and safety goggles when working on the filter
system.
Locks (2x)
1
Filter casing cover
2
Filter box
3
1. Switch off the device and switch it off using the ON/OFF
switch.
2. Open the cover.
3. Open the locks.
4. Swing the cover upwards.
5. Remove the filter box with the dust filter upwards.
Filter box
1
Dust filter (HEPA)
2
Removable pre-filter
3
6. Check the dust filter and pre-filter.
a To clean, vacuum the dust filter or knock it out together with
the filter box (do not wash out).
b Pull out the pre-filter and clean it.
7. Check and clean the filter scraper.
8. If damaged or heavily soiled, insert a new dust filter or pre-filter
in the filter box.
9. Note the installation direction of the filter box during installa-
tion.
Change the side brush
Changing the side brush is described for when the device is tilted.
ATTENTION
Risk of injury and damage
Before tilting the device, remove the battery and the sweep con-
tainer.
Secure the tilted device before changing the side brush.
lock
1
Side brush
2
Mount
3
1. Remove the waste container.
2. Remove the battery.
3. Tilt the device backwards and secure it against tipping down.
4. Unscrew the lock on the underside.
a To open: turn counterclockwise
b To close: turn clockwise
5. Remove the side brush.
6. Clean the mount if necessary.
7. Place the new side brush on the mount and secure it with a
lock.
Check/change the roller brush
Check and change the roller brush with the device tilted.
ATTENTION
Risk of injury and damage
Before tilting the device, remove the battery and the sweep con-
tainer.
Secure the tipped device before changing the roller brush.
When inserting the new roller brush, make sure that no bristles
are caught in the bore of the roller brush arm.
Bearing shell
1
Roller brush
2
Drive pin
3
Distance between sealing strip and retaining plate
4
– Target: 1.18 in (30 mm)
1. Remove the battery.
2. Remove the waste container.
3. Tilt the device backwards and secure it against tipping down.
4. Remove the wrapped straps and cords from the roller brush.
5. Remove dirt from the drive pin.
6. To change the roller brush, press the bearing shell.
7. Pull the roller brush out downwards.
English 7