Kaco blueplanet 100 NX3 Manual Del Usuario página 166

AC-side
Cable diameter for cable fitting
Length of insulation to be stripped off
Cable lug Ø connection bolt
Tightening torque
Connection type
Cable lug dimension w - maximum width
Ground conductor connection
Ground conductor connection tightening torque
Fuse protection for installation provided by customer (max
output overcurrent protection)
Fitting for AC connection
Torque for cable fitting
Interfaces
Cable diameter for cable fitting
Torque for cable fitting
RS485 connection type
RS485 terminal cable cross-section
Cable diameter for cable fitting
Torque for cable fitting
Ethernet cable cross-section
Ethernet connection type
PID connection type
Requirement - connection to power supply
Operating voltage (DC)
Operating current (DC)
Type of connection
Cable diameter for cable fitting of the optional voltage supply
for external PID box
Conductor cross-section
Torque for cable fitting
Page 166
16 – 28 mm
Depending on the cable lug
Bore for M10 screw
30 Nm
Cable lug (use the appropriate cable lug depending on
the cable material!)
42 mm
M10
10 Nm
500A
M40
10 Nm
(2x) 8 - 17 mm
4 (M25) Nm
Screw connection or spring-type terminal
0.14 mm² ... 1.5 mm²
(1) 8 - 17 mm
4 (M25) Nm
Standard Cat5 0.5-0.7 mm²
RJ45
defined by external solution (e.g. Padcon)
24 V
max. 0.5 A
Connector
5-10 mm
0.2-1.5 mm²
22 In-Ibs
(M16) 2.5 Nm
M8 & M10