Goodyear GY 26LS Manual De Instrucciones página 21

English • Owner´s manual
Thank you for buying our machine.
This manual contains information on the use and maintenance of the machine. This information is based
on the latest product information available at the time of approval for printing. We reserve the right to
make changes without prior notice and without incurring any other obligation.
This manual should be considered as a permanent part of the machine, which must accompany it if it is
resold or borrowed.
1. SAFETY INFORMATION
Safety is as important to you as to others. We have detailed the most relevant safety information in both
the manual and the machine. Please read it carefully.
This safety information warns you that there is a potential danger to you as well as others. The keywords
are marked with a "!" Located in front of the information to be highlighted. These words are "Danger,
Warning, Attention" / "Danger, Warning, Attention. "
DANGER / DANGER
If you do not follow the instructions in this manual, you may suffer serious injuries and even death.
WARNING / WARNING
Indicates the possibility of personal injury or damage to the equipment if you do not follow the instructions.
ATTENTION / ATTENTION
If you do not follow the instructions in this manual, you may damage the machine or be injured.
Damage prevention
You will see other important information marked "ATTENTION".
ATTENTION: If you do not follow the instructions in this manual, you may damage the machine.
Prevention and safety
If you use the machine following the instructions in this manual, it will work safely and without problems.
Before using the machine, please read this manual carefully. Otherwise, you may suffer an injury or damage
the machine.
Circled or crossed symbols indicate that it is prohibited.
2. SAFETY SYMBOLS
Before using the equipment
• Operators must be fully trained before using this machine.
• Read and understand the user manual.
• The machine must be placed on a level ground, all protections installed and in good condition.
• Blades must be in good condition. All blades must be sharp or if they are damaged they must be repla-
ced with new ones.
• Check that all fasteners are snug.
21