Metabo HPT WR 18DH Manual De Instrucciones página 20

English
Problem
Tool suddenly stopped
Tool sockets
-can't be attached
-fall off
-can't be removed
Switch can't be pulled
An abnormal high-pitched noise
occurs when the trigger switch is
pulled.
WARNING
ALWAYS use Only authorized metabo HPT replacement parts and accessories. NEVER use replacement
parts or accessories which are not intended for use with this tool. Contact metabo HPT if you are not sure
whether it is safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE
Accessories are subject to change without any obligation on the part of the metabo HPT.
STANDARD ACCESSORIES
WR18DH
(2LA)
WR18DH
(NN)
OPTIONAL ACCESSORIES
1. Battery (BSL1840M)
20
Possible Cause
Tool was overburdened
The battery is overheated.
The trigger switch was held down for
5 minutes or more.
The shape of the attachment portion
doesn't match
Pushing button is positioned halfway
The trigger switch is being pulled only
slightly.
ACCESSORIES
1. Battery Charger (UC18YFSL) ........................................................................ 1
2. Battery (BSL1840M)....................................................................................... 2
3. Battery cover (Code No. 329897) ................................................................... 1
4. Bag (Code No. 375801M)............................................................................... 1
Battery, battery charger, plastic case and battery cover are not contained.
Possible Solution
Get rid of the problem causing the
overburden.
Let the battery cool down.
This is not a malfunction.
The motor was automatically stopped
to prevent failure of the tool.
Be sure to use 12.7 mm square drive
sockets.
Press the button firmly into position
for the desired direction of rotation.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.