Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Always hold the trimmer away from the body keeping
clearance between the body and the trimmer. Any contact
with the trimmer cutting head while operating can result
in serious personal injury.
CUTTING TIPS
See Figure 17.
„ This product is designed to cut small weeds, grass or
similar soft vegetation.
„ Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
„ The trimmer cuts when passing the unit from left to right.
This will avoid throwing debris at the operator. Avoid cut-
ting in the dangerous area shown.
„ Use the tip of the line to do the cutting; do not force string
head into uncut grass.
„ Wire and picket fences cause extra line wear, even break-
age. Stone and brick walls, curbs, and wood may wear
line rapidly.
„ Avoid trees and shrubs. Tree bark, wood moldings, sid-
ing, and fence posts can easily be damaged by the line.
OPERATION
ADVANCING THE CUTTING LINE ON THE
BUMP FEED TRIMMER HEAD
See Figure 18.
„ Line advance is controlled by tapping the string head on
the ground while running motor at full speed.
„ Depress the switch trigger completely.
„ Tap the bump knob on ground to advance line. The line
advances each time the knob is tapped. Do not hold the
knob on the ground.
NOTE: The line trimming cut-off blade on the grass
deflector will cut the line to the correct length.
NOTE: If the line is worn too short you may not be able to
advance the line by tapping it on the ground. If so, remove
the battery pack and manually advance the line.
To advance the cutting line manually:
„ Remove the battery pack.
„ Push the bump knob in while pulling on line(s) to manually
advance the line.
„ Resume trimming.
NOTICE:
Failure to attach the grass deflector prevents the line
being cut to the proper length and can cause tool failure.
12 — English
Publicidad
