Ryobi PBLBC01 Manual Del Operador página 9

„ Maintain a firm grip with both hands on the machine
and position your arms to resist blade thrust. Position
your body to the left side of the machine. Blade thrust
can increase the risk of injury due to the machine mov-
ing unexpectedly. Blade thrust can be controlled by the
operator if proper precautions are taken.
„ If the blade binds, or when interrupting a cut for any
reason, switch the machine off and hold the machine
motionless in the material until the blade comes to a com-
plete stop. While the blade is binding, never attempt to
remove the machine from the material or pull the machine
The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
BRUSH CUTTER SAFETY RULES
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Safety Alert
Read Operator's
Manual
Wear Eye, Hearing,
and Head Protection
Wet Conditions Alert
Wear Gloves
backward while the blade is in motion, otherwise blade
thrust may occur. Investigate and take corrective actions
to eliminate the cause of blade binding.
„ Do not use blunt or damaged blades. Blunt or damaged
blades increase the risk of jamming or catching on an
object, resulting in blade thrust.
„ Always maintain good visibility of the material being cut.
Blade thrust is more likely to occur in areas where it is
difficult to see the material being cut.
„ If you are approached by another person while operating
the machine, switch the machine off. There is an increased
risk of injury to other persons being struck by the moving
blade in the event of blade thrust.
SYMBOLS
DESIGNATION/EXPLANATION
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand operator's
manual before using this product.
Wear eye protection with side shields marked to comply with ANSI
Z87.1 as well as hearing and head protection when operating this
equipment.
Risk of fire and burns. Do not expose battery, battery compartment,
or electronic components to rain, water, or liquids. Do not operate
on wet ground.
Wear non-slip, heavy-duty protective gloves when handling this
equipment.
5 — English