Publicidad
GB
Separator removal and cleaning
1
4
Clean water tank outlets
1
A
Make sure the clean water tank is empty.
Unscrew the two clean water outlets, A
and B.
2
A
2
B
Remove the clean water outlets from the
clean water tank.
Regular Maintenance
5
Once the separator has been removed, wash thoroughly under a
tap making sure to run water through the tubes and to clean the
Once clean thoroughly check the rubber seal for any damage or
cracks (B).
If any damage or cracks are found on the rubber seal replace
the separator. Failure to replace could cause loss in suction and
machine performance.
Wash the clean water outlets thoroughly
with no blockages. Check for any damage
(if any damage is found replace the clean
water outlets).
37
37
3
3
B
Publicidad
