Create Wipebot Pro Manual De Instrucciones página 10

4. Make sure the mop holder is installed in the correct position before use. After installing
the bracket, observe from the sides at 360º to make sure each snap is glued in place to
prevent air leaks.
5. Insert the wiper power cord into the end of the adapter and tighten them. Connect the two
ends of the AC cable to the adapter and plug respectively.
6. Press and hold the power button for 3 seconds and the robot will turn on. After the fan is
running, place the robot on the glass in a place away from the window frame. If the robot
cannot suction the glass, check for an air leak.
10 E NGL I SH
On/off button