Create Wipebot Pro Manual De Instrucciones página 12

Protection against power outages
1. This robot is equipped with an internal battery, which can keep the robot powered on for
20 minutes in case the robot is accidentally disconnected from the power cord. The robot
will give an audible and visual alarm, please remove the robot from the glass as soon as
possible.
2. When the indicator light is red before turning on the device, it means that the internal
battery is too low to start the robot. Please keep the robot connected to electricity to
charge until the red light goes off.
sprays water and the right nozzle does not spray water.
3. After cleaning is completed, the robot will stop at the bottom left or right corner depend-
ing on the shape of the glass.
Note: When the robot starts working, it will rise to the upper right corner of the glass. The
left and right nozzles will not spray water when the robot moves from the upper right corner
to the upper left corner for the first time, even with the water spray function activated (de-
fault software setting).
12 E NGL I SH
REMOTE CONTROL
Light
To turn off
Pause
Small water sprayer
Spot cleaning
ROUTE PLANNING
1. Place the glass cleaner in the center of the glass, away
from the window frame. Press and hold the power button
to turn on the robot, and then short press the button to
start it. The robot will automatically move up and then to
the right until it reaches the top right corner of the glass.
2. After the robot has reached the upper right corner, it will
begin to clean the glass by drawing an S-shaped curve
from top to bottom. If the robot's water spray function is
activated, when the robot moves to the right, the right
nozzle sprays water and the left nozzle does not spray
water. When the robot moves to the left, the left nozzle
Above
Below
Left
Right
Large water sprayer
Turn on/off water spray
Clean x2