Create Wipebot Pro Manual De Instrucciones página 11

safety rope
Check if the safety rope is intact and on a stable object.
Work environment inspection
• Make sure the glass surface is dry, do not use it when it is raining or when the glass surface
is foggy.
• Do not use on broken and cracked glass.
• If working at height outdoors is required, ground safety warnings should be set to prevent
accidental personal injury.
• The robot cannot be used when there are adhesives or oil on the glass surface, to prevent
the robot from slipping and falling from the glass.
Wet and dry towel
If there is sand or dust on the glass surface, it is recommended to clean it manually first to
avoid scratching the glass when the robot is working. If manual cleaning is not possible, it is
recommended to turn off the water spray function and use dry mops to clean sand and dust
first.
If there are only dirt stains, it can be cleaned directly with the water spray (activate the water
spray by default).
If there are slips and twists when the robot goes up, install a dry towel and turn on the water
spray.
If there are small areas of stubborn stains, you can use "spot cleaning" and turn on the water
spray.
If the robot experiences strong shaking or rattles, install a dry cloth.
Begin
1. Make sure the power cord and plug are fully connected.
2. Press and hold the power button for 3 seconds and the robot will turn on.
3. When the robot motor starts working, place the robot on the glass in a place away from the
window frame. Make sure the robot has completely stuck to the glass and then release it.
4. Short press the power button and the robot will start working.
Remove the robot from the glass
1. When the robot is working, hold the safety cable with one hand and short press the power
button to stop the robot and lower it with the other hand.
2. If you can't reach the robot and don't have the remote control at hand, please stay close to
the glass to drag the safety rope and slowly pull the robot to the accessible place by hand,
then press the power button and remove the robot from the glass .
3. After completely disassembling the robot, press and hold the power button for 3 seconds
to turn it off.
INSTRUCTIONS AND PRECAUTIONS
E NGLISH 11