Create Wipebot Pro Manual De Instrucciones página 14

1. When the error indicator flashes red with short continuous beeps, check whether:
• The power cord plug is loose or damaged causing power outage or poor contact.
• The glass or mop is too wet and the friction is too low.
• The glass has impurities attached and causes too high friction.
• The mop holder is installed incorrectly causing air leaks.
• The glass surface is sticky.
2. The error indicator flashes red and green alternately with an alarm beep.
• It means that a problem occurs in the internal hardware of the robot, please contact cus-
tomer service.
• In the case of special glass, when cleaning the bottom of the glass, it needs more time to
clean, please use the remote control.
• In case the robot cannot walk freely, change the mop or inspect the screws of the clean-
ing roller, make sure they are not loose.
3. In case the robot cannot walk freely, replace the mop or inspect the screws of the cleaning
roller and make sure they are not loose.
4. If the robot mop holder shakes too hard when the robot is working, check whether the mop
is too wet and replace it with a dry mop.
5. There will be a little delay in water spraying when the robot starts working, this is a normal
phenomenon.
6. After cleaning, there are residual round marks left on the glass surface, please change
the mop again.
7. After completing the entire cleaning process, the robot continues to move and does not
stop automatically. Press the pause button and take him down.
8. When in use, errors may occur occasionally, please restart the robot as a solution.
9. If there is downward sliding when the robot is working, check whether:
• The mop is too wet or too dirty.
• The robot cannot resume work after a while, please replace the mop with a clean and
dry one.
• The mop is too dry to cause slipping, turn on the water spray function to moisten the mop
and then the robot can resume work.
10. Cause of air leak, check if:
• The mop holder is installed correctly.
• The installation of the cleaning mop to achieve flatness.
• The surface of the glass or other target surface is curved or covered with irregular sur-
faces, such as stickers.
• The robot goes to the window frame, the mop holder will be deformed to produce a wide
range of air leaks.
14 E NGL I SH
TROUBLESHOOTING