Publicidad
Idiomas disponibles
Idiomas disponibles
10. To prevent rutting or grooving of the turf, if possible, change the direction
that the strips are mowed by approximately 45° for the next and each
subsequent mowing.
Be careful when crossing gravel paths or driveways. Disengage the PTO knob
and raise the deck to the highest/transport position before crossing.
NOTE: When stopping the mower for any reason while on a grass surface, always:
• Make sure the drive pedals are in neutral.
• Engage the parking brake.
• Shut engine off and remove the key.
• Doing so will minimize the possibility of having your lawn ''browned'' by
hot exhaust from your mower's running engine.
SUREPATH AUTO STEER SYSTEM
Make certain the area to be mowed is free of debris, sticks, stones, wire, or
other objects that can be thrown by the rotating blades.
The SurePath Auto Steer system will not detect any objects or obstructions
in the path of the cutting deck or the machine. Always operate the machine
with care and attention. Stop the machine immediately or manually steer
the machine around obstacles before resuming SurePath Auto Steer Mode.
The SurePath Auto Steer system uses GPS technology to semi-autonomously control
steering and turning capabilities to achieve consistent stripes, reduce turfing and
maximize mowing efficiency.
Initializing SurePath Auto Steer Mode
1. Start the mower. See instructions provided in Starting the Engine section.
2. Indicator/Warning Lights will flash blue while the SurePath Auto Steer system
is initializing.
3. Once the system has initialized, Indicator/Warning Lights will begin flashing
green. The SurePath Auto Steer system is actively searching for GPS signal.
SurePath Auto Steer Infinite Set Lines
SurePath Auto Steer Mowing
Manual Mowing
Press and Release
*
WARNING
WARNING
WARNING
*
OPERATION
IMPORTANT! Machine should be outdoors, away from large trees and buildings
in order to acquire signal.
NOTE: Signal acquisition will take approximately 90 seconds.
4. Once signal is acquired, Indicator/Warning Lights will turn solid green. The
mower is now ready for SurePath Auto Steer Mode. See Figure 26 for a list of
Indicator/Warning Light colors and descriptions.
Descriptions
System Initializing
Attempting to Acquire GPS Signal
GPS Signal Acquired
Mower Speed too Fast for
SurePath Auto Steer Mode
Grab and Turn Wheel to Override
SurePath Auto Steer Mode
Software Update in Process
* Also indicates a button press ignored by the system
† Periodic red flash indicates no cellular connectivity
# See authorized dealer for more information
B*
Setting the Mowing Line (SurePath Auto Steer Mode)
A*
1. Start the mower. See instructions provided in Starting the Engine section.
NOTE: PTO does not need to be engaged to set mowing line.
2. Once indicators on the Indicator/Warning Lights are solid green, the system is
ready for SurePath Auto Steer Mode.
3. Set your mowing line by performing the following steps:
• Determine the first pass location, picking a point on the opposite side of the
area to be mowed.
• Drive in a straight line toward point chosen in the previous step and briefly
press the SET LINE/ENGAGE AUTO button on the Operator Control Panel to
set point A (Figure 27). The LINE indicator will begin flashing green when
point A is set.
Left turn (as shown) or right turn*
Figure 27
22
Indicator/Warning Light Colors
Flashing Blue
Flashing Green †
Solid Green
Flashing Yellow *
Flashing Red
Solid Yellow #
Figure 26
B*
A*
>10 yards (30 feet)
Publicidad
