Cub Cadet Pro Z SurePath Manual Del Operador página 38

Changing the Transmission Drive Belt
Several components must be removed and special tools used in order to change
the mower's transmission drive belt. See your authorized service dealer to have the
transmission drive belt replaced.
Mower Creeping
Creeping is the slight forward or backward movement of the mower when the
throttle is on and the speed control pedals are in the neutral position. If your mower
creeps, see your authorized service dealer.
SUREPATH AUTO STEER SYSTEM
NOTE: SurePath Auto Steer system functionality requires connectivity to software
and services. The first year of your subscription is included in the price of the product.
All following years will need to be renewed at the current subscription cost. For more
details, and to purchase a subscription, please visit cubcadet.com/surepath.
Maintenance
• Never wash the GPM. If necessary, wipe the GPM with a clean micro-fiber towel
only. Never cover the GPM antenna. Covering the GPM antenna, even with certain
kinds of stickers, will inhibit GPS signal which will disable autonomous function
(Figure 64).
Do not block GPM.
TROUBLESHOOTING
Before cleaning, repairing, or inspecting, make certain the blade(s) and all moving parts have stopped. Turn off the engine, remove the key, disconnect the
spark plug wire(s) and the negative battery cable to prevent unintended starting. Always wear safety glasses or safety goggles during operation and while
performing an adjustment or repair to protect your eyes.
This section addresses minor service issues.
Problem
Excessive vibration
Uneven cut
Mower will not mulch grass
Engine fails to start
PRODUCT CARE
WARNING
Cause
1. Cutting blade loose or unbalanced.
2. Damaged or bent cutting blade.
1. Deck not properly leveled.
2. Cutting blade dull or damaged.
3. Uneven tire pressure.
1. Engine speed too low.
2. Wet grass.
3. Excessively high grass.
4. Dull blade.
1. PTO/Blade engaged.
2. Blown fuse.
3. Parking brake not engaged.
• Debris can accumulate anywhere on the mower, especially on horizontal surfaces.
Additional cleaning may be necessary when mowing in dry conditions or
when mulching.
• Fuel leaks/spills, oil leaks/spills and excess lubrication can also become collection
sites for debris. Immediate repair and cleaning up oil or fuel spills can help reduce
fire hazards.
• In addition to cleaning the mower before operating and storing, do not attempt
to mow unusually tall grass (10" or higher), dry grass (e.g., pasture) or piles of dry
leaves. Dry grass or leaves may contact the engine exhaust and/or build up on the
mower deck presenting a potential fire hazard.
Global Positioning Module (GPM)
Do not attempt to modify or repair the GPM. Please see an authorized service dealer
for any issues with the GPM.
WARNING
1. Tighten blade and spindle.
2. Replace blade.
1. Perform side-to-side deck adjustment.
2. Sharpen or replace cutting blade.
3. Check and correct tire pressure in all four tires.
1. Place throttle in FAST (rabbit) position.
2. Do not mulch when grass is wet.
3. Mow once at a high cutting height, then mow again at desired
height or make a narrower cutting swath.
4. Sharpen or replace blade.
1. Place blade engage lever in disengaged (OFF) position.
2. Replace fuse(s). Replace with same rating fuse, if necessary.
3. Engage parking brake.
See Engine Operator's Manual.
38
Figure 64
Remedy