Publicidad
Idiomas disponibles
Idiomas disponibles
The following measures will help to avoid switching
errors of this kind:
• Allow a distance of at least 5 m between lights.
• Interconnect lights via the Steinel Connect App
and selectively deactivate the sensor in individual
lights via the Sensor-Off function (Fig. B + C).
As a result of interconnection, movement will also
switch lights ON in spite of their sensor being
deactivated.
Note:
The high-frequency output of the iHF sensor is
is approx. 1 mW – 1,000 times less than the trans-
mission power of a mobile phone or microwave oven.
Note:
The sensor is suitable for switching light on auto-
matically. Note: weather conditions may affect the
way the sensor works. Strong gusts of wind, snow,
rain or hail may cause the light to come on when it
is not wanted.
5. Electrical connection
To achieve the stated reach of 5 m, the light should
be mounted at a height of approx. 2 m.
Connecting the mains power supply lead
(see diagram)
The supply lead is a three-core cable:
L
=
phase conductor (usually black,
brown or grey)
N
=
neutral conductor (usually blue)
PE =
protective-earth conductor (green / yellow)
If you are in any doubt, identify the conductors
using a voltage tester; then disconnect from the
power supply again. Phase (L) and neutral conduc-
tor (N) are connected to the terminal block.
Important:
Incorrectly wired connections will produce a short
circuit later on in the product or your fuse box. In
this case, you must identify the individual conduc-
tors once again and reconnect them.
Note:
The light source of this luminaire cannot be re-
placed. If the light source needs to be replaced (e.g.
at the end of its service life), the complete luminaire
must be replaced.
A mains power switch for turning the unit ON and
OFF may of course be installed in the mains supply
lead.
6. Functions
The sensor-switched light can be put into service
after mounting the enclosure and connecting to the
mains power supply. When putting the light into
operation manually at the light switch, it will switch
OFF after 1 second for the calibration phase and is
then activated for sensor mode.
It is not necessary to operate the light switch a
second time.
Functions can be set via Steinel Connect App
(L 800 SC / L 800 C / L 810 SC / L 810 C /
L 820 SC) or control dial.
Note:
The settings last selected on the control will be used.
Steinel Connect App
To configure the light via smartphone or tablet, you
must download the Steinel Connect App from your
app store. You will need a Bluetooth-capable smart-
phone or tablet.
QR codes
Android
Functions:
Following functions can be set via the Steinel
Connect app:
– Time setting 5 s – 60 min.
– Twilight setting 2 – 2,000 lux
– Teaching lux
– Basic light level
– Main light level
– Soft light start function
– 14 –
iOS
Publicidad
