STEINEL L 800 Manual Del Usuario página 15

– Teaching time of day
– Reach adjustment
– Bluetooth interconnection
Time setting
The stay-ON time can be set to any period from
approx. 5 seconds to a maximum of 60 minutes.
Every movement detected re-activates the light.
The shortest time setting is recommended when
adjusting the detection zone and performing the
functional test.
Twilight setting
The brightness response threshold (twilight) can be
infinitely varied from approx. 2 – 2,000 lux.
Daylight mode must be selected when adjusting the
detection zone and performing the functional test in
daylight..
Basic light level
The brightness of the basic light level setting can be
varied between 0% and 100%.
Basic light can be set in relation to time or ambient
light level.
The light switches to maximum output (100%) for
the time selected in response to movement in the
detection zone. The light then returns to the basic
light level.
Main light level
The brightness of the main light level setting can be
varied between 0 % and 100 %.
Soft light start function
On switching ON, light level constantly builds up to
100 % (fade in).
On switching OFF, light level is constantly reduced
to 0 % (fade out).
Fade-in and fade-out times are selectable.
Manual override
The manual override parameters can be set via the
Steinel Connect app. In the new app, manual over-
ride can be set to any specific time of day (teaching
time of day).
Bluetooth interconnection (Bluetooth Connect
mesh)
The sensor switch complies with the Bluetooth
Mesh standard. It can be interconnected with
all products complying with the Bluetooth mesh
standard.
The sensor switch is configured via the Steinel
Connect app. Appropriate network keys are saved
on a smartphone or tablet the first time a connecti-
on is made between the sensor switch and Steinel
Connect app. The key rules out any unauthorised
access to the sensor. The network key must be
shared for access via another smartphone or tablet.
What is soft light start?
The sensor-switched light features a soft light start
function. This means that when turned ON, the
light is not switched directly to maximum output
but gradually builds up brightness to 100 % within
the space of a second. Brightness is also gradually
reduced when the light is switched OFF.
Note:
Depending on the local power grid, the LED's may
flicker slightly when dimmed. This is not a product
defect and no reason for complaint.
7. Maintenance / care
The product requires no maintenance.
The light can be cleaned with a damp cloth (without
detergents) if dirty.
Important note: the control gear cannot be
replaced.
8. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmen-
tally compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be col-
lected separately and recycled in an environmentally
compatible manner.
– 15 –
GB