Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
9.1
Inserting/removing the battery (5)
in the battery mount (6) (Fig. 2)
Inserting the battery
1. Put the rotational direction switch (10) in the middle
position (lock).
2. Push the battery (5) into the battery mount (6). The
battery (5) clicks into place audibly.
Removing the battery
1. Press the unlock button (7) of the battery (5) and re-
move it from the battery mount (6).
9.2
Check the charge status of the
battery
The charge status indicator (28) indicates the charge
status of the battery (5).
The charge status of the battery is indicated by the cor-
responding LED light lighting up.
1. Press the charge status indicator button on the bat-
tery (27).
LED on the battery
Charging status
red-orange-green
Battery full
red-orange
Battery partially charged
red
Battery empty
9.3
Charge battery (5)
Charge the battery at an ambient temperature of 4 °C
to 40°C.
* = not included in the scope of delivery!
1. Push the battery (5) into the battery mount up to the
stop.
2. Plug the mains plug into the socket. The LED strip
(14) lights up green.
28 | GB
3. As soon as the charging process starts, the LED
strip (14) flashes green.
4. The LED strip (14) lights up green when charging is
complete. The battery (5) is ready for use.
ATTENTION
–
If the red LED strips flash, the battery has over-
heated and cannot be charged.
–
If the LED strip flashes red and green alternately,
the battery is defective.
5. Pull the battery (5) out of the battery holder.
6. Wait at least 15 min until a new charging process.
Therefore, pull the mains plug out of the outlet.
9.4
Depleted batteries
• A significantly shortened operating time despite
charging indicates that the battery has been used
up and needs to be replaced. Only use original re-
placement batteries.
• In any case, observe the applicable safety instruc-
tions as well as regulations and instructions on envi-
ronmental protection (see "Disposal and recycling").
9.5
Inserting/removing the tool
attachment
WARNING
Tool attachments may be sharp and become hot
during use. Always wear protective gloves when han-
dling the tool attachments.
CAUTION
Keep your hands away from the tool attachment
when the product is in operation.
1. Turn the quick-release chuck (2) anti-clockwise until
the chuck opening (1) is large enough to insert the
tool attachment.
2. Insert the tool attachment into the quick-release
chuck (2) as far as possible.
3. Turn the quick-release chuck (2) clockwise to clamp
the tool attachment tight.
4. To remove the tool attachment again, untwist the
quick-release chuck (2) and remove the tool attach-
ment.
9.6
Test run
Note:
Before the first work and after each tool attachment
change, carry out a test run without load. Switch off the
product immediately if the tool attachment runs out of
round, there is considerable vibration or abnormal nois-
es are heard.
www.scheppach.com
Publicidad
