Publicidad
Idiomas disponibles
Idiomas disponibles
1. Before operation, check whether the tool attach-
ment is properly attached, i.e. centred in the quick-
release chuck (2).
2. Screw bits are marked with their dimensions and
shape. If you are unsure, always try out first wheth-
er the bit sits in the screw head without play.
9.7
Gear selection
1. Push the gear selector switch (4) to 1
sponding to a low or high speed selection.
Gear 1 :
Suitable for:
Rotational speed:
Torque:
Gear 2 :
Suitable for:
Rotational speed:
Torque:
9.8
Set direction of rotation
ATTENTION
The direction of rotation switch may only be actuated
when idle.
With the direction of rotation switch, you can select the
direction of rotation of the product (clockwise or anti-
clockwise) and secure the product from being switched
on unintentionally. The arrow on the direction of rotation
switch indicates the working direction.
1. Wait until the product has come to a standstill.
2. Push the direction of rotation switch (10) to the de-
sired position:
– Clockwise rotation: For drilling and screwing
in screws. Press the direction of rotation switch
to the right.
– Anti-clockwise rotation: To undo screws.
Press the direction of rotation switch to the left.
3. Switch lock: Put the direction of rotation switch in
the centre position.
9.9
Adjusting the torque
ATTENTION
The torque adjusting ring may only be actuated when
idle.
Note:
A clear ratcheting sound is heard when reaching the
preset torque limit. This noise is caused by the slip
clutch.
Note:
You can preset the maximum torque by turning the
torque adjusting ring (3). There are 25 torque levels + 1
drill level.
1. Select the desired torque by turning the torque ad-
justing ring (3).
2. Start with a lower torque level and increase it as re-
quired.
or 2 corre-
Level 1
Level
0 – 420 rpm
Screws
Screwing work
Drilling
Low
High
9.10
The speed can be steplessly controlled by the on/off
0 – 1500 rpm
switch. The further you press the on/off switch, the
Drilling work
higher the speed.
High
1. To switch on the product, push the on/off switch (9).
Low
2. To switch off, release the on/off switch (9).
If you put the direction of rotation switch (10) in the
centre position, the product is secured from being
switched on.
9.10.1
This product is equipped with an LED work lamp to illu-
minate the immediate work area and improve visibility
in poorly lit environments.
Do not look directly into the LED work lamp or the
light source.
1. The LED work lamp (8) lights up automatically as
soon as the product is switched on.
Note:
The LED work lamp remains lit up for approx. 10 sec-
onds after the product is switched off.
10 Accessory set
10.1
1. Press the unlocking on the cutter knife (24) to pull
out the insert with the spare blades.
10.2
1. Push the locking slider forward to fix the pulled out
measuring tape (21).
2. Release the fixation by pulling back the locking slid-
er.
3. Press and hold one of the locking buttons to tempo-
rarily fix the pulled-out measuring tape (21).
4. With the clip, on the back, you can attach the mea-
suring tape (21) to the belt.
www.scheppach.com
On/Off switch (9) (Fig. 1)
LED work lamp (8)
CAUTION
Cutter knife (24)
Measuring tape (21)
Lowest torque
Highest torque
Level 1 - 25
Level
GB | 29
Publicidad
