Fein ABSS18-1.6 E AS Instrucciones De Uso página 17

Working instructions.
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by
FEIN. The use of non-original FEIN accessories can lead to overheating of the power tool
and destroy it.
For each job, use only the FEIN application tool released and intended for
CAUTION
the respective application.
Switching on and off.
Guide the power tool toward the work
piece only when switched on.
While cutting, hold the power tool as
upright as possible to the work-piece sur-
face (ABLS (**)).
Guide the power tool uniformly and with
light feed in the cutting direction. Excessive
feed considerably reduces the tool life of the
application tools.
Do not cut steel sheets where welded. Do
not cut layered sheets exceeding the max.
work-piece thickness.
Switching on and off (figure 5).
Switching on:
Push the switch toward the front (I).
Switching off:
Push the switch toward the rear ().
To increase the tool life of the blades, it is
recommended to apply a lubricating agent
alongside the intended cutting line:
– For cuts in steel sheet: Use cutting paste
or cutting oil.
– For cuts in aluminum: Use petroleum.
Do not switch the power tool off until after
having removed it from the cutting path.
The symptom for worn blades is a clearly
increased feed force at lower working prog-
ress.
Fig. 5
On/Off switch
en
17