Fein ABSS18-1.6 E AS Instrucciones De Uso página 20

en
20
Changing the tool (ABSS18-1.6 E AS (**)).
Before mounting or replacing application tools or accessories, remove the
WARNING
battery. This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
For inside cuts, a pilot hole is required; see "Technical Data".
Cutter blades and cutting bars cannot be reground.
Replacing cutter blades (figure 8).
Press the engaged supporting pin out in lat-
eral direction until the cutter blade can be
removed.
Pull the cutter blade out of the cutter head.
Lightly grease the supporting pin and the
new cutter blade.
Insert the new cutter blade. Slide the sup-
porting pin through the hole of the cutter
blade until it engages.
Turning or replacing cutting bars
(figure 9).
Loosen the screws with the hex key.
When the front half of the cutting edges on
the cutting bars are dull, turn the cutting bars
by 180° and mount them each to the oppo-
site side.
When both cutting edge halves are dull,
replace the cutting bars.
Fig. 8
4.
3.
2.
5.
Supporting
pin
4.
Fig. 9
Cutting bars
4.
3.
4.
3.
Cutter blade
4.
1.
6.
5.
2.
1.
Screws
5.
2.
1.