Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
5. Wait until all the water has drained.
6. Now unscrew the filter completely and remove it.
7. Clean the filter and the filter chamber.
8. Check that the pump rotor moves freely.
9. Re-insert the filter and screw it in clockwise as far as it will go.
10. Reinstall the plinth.
11. Plug in the appliance once again.
12. Select a programme and start it.
Draining residual water
Before emptying the residual water, switch the appliance off
and unplug it from the mains socket. Remove the plinth. Place
a container beneath it.
1. Open the filter but do not remove it completely. Slowly turn
the filter counterclockwise until the water begins to drain out.
2. Wait until all the water has drained.
3. Now unscrew the filter completely and remove it.
4. Tilt the appliance forward carefully to allow the water to flow
out.
5. Refit the filter and screw it in clockwise as far as it will go.
6. Refit the plinth.
Care and maintenance
Appliance exterior and control panel
• Can be washed down with a soft, damp cloth.
• A little neutral detergent (non abrasive) can also be used.
• Dry with a soft cloth.
24
EN
Publicidad
