Publicidad
Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Problem
Final spin results are poor.
Enter the after-sales query mode
1.
In the OFF mode, press the «Temp.» + «Options» + switch the «
sales inquiry mode.
2.
It displays the number of operation cycles.
3.
Press «Options» to switch cycles or fault codes.
4.
When querying fault codes, press the «Temp.» to page up and the «Spin» to page down.
5.
Turn the knob to «OFF», wait for 3 seconds, you will exit query mode.
Ensure that:
•
All connections are tightly fixed.
•
Do not allow children to operate, crawl on, be near or inside your washer.
•
Note that during the wash cycles, the surface temperature of the porthole
door may increase.
•
Close supervision of children is necessary when the appliance is used near
children.
Error code
Displayed on Display Window
"F01"
"F03"
"F04", "F05", "F06", "F07","F23" and
"F24"
"F13"
"F14"
"Unb"
Check whether / Possible cause
The washing machine has an imbalance detection and
correction system. If individual heavy items are loaded
(e.g. bathrobes), this system may reduce the spin speed
automatically or even interrupt the spin completely if it
detects too great an imbalance even after several spin
starts, in order to protect the washing machine.
• If the laundry is still too wet at the end of the cycle,
remove some articles of laundry and repeat the spin
cycle.
• Excessive foam formation may prevent spinning. Use
the correct amount of detergent.
• Check that the spin speed selector has been set to
" 0 ".
Fault Code List
Electronic module fault, overflow or too
28
EN
» to enter the after-
Fault Description
Water inflow fault
Drainage fault
much foam.
Door lock fault
Door unlock fault
Unbalance alarm
Publicidad
