JOCCA 2145 Manual De Instrucciones página 11

shown in figure 3
3. When you close the lid, by turning it clockwise, you must make sure that the lid hook (c) is
attached to the pitcher spout, at the same time that it is assembled on the pitcher handle, figure 2.
IMPORTANT: The appliance can only be turned on once the lid is perfectly closed.
Otherwise E03 error will flash on the control panel.
USING MEASURING CAP
1. The measuring cap is used to cover the jug and at the same time, dose the ingredients that are
added (from 80 to 100 ml).
2. To cover the jar, place the measuring cap on the lid, with the opening facing down, and close
it by turning it clockwise.
3. The measuring cap can be briefly removed to add food.
IMPORTANT: Before removing the measuring cap, you must reduce the speed to level 2
to avoid food splashes.
USING THE BLADE COVER
1. The blade cover is for mixing without cutting, it must be attached to the blades. Place it over
the blades and gently squeeze until it clicks
2. Remove the blade cover by pulling it up. If it gets stuck, turn it around a bit.
IMPORTANT:
- The blade guard can only be used with slow speeds, from 1 to 4.
- The Turbo button should not be pressed if the blade guard is in use.
USING THE STEAM BASKET
1. Pour at least 0.5 l of water (up to the first level) into the jug. .
2. Put the food in the steamer basket.
3. Place the steam basket in the jug using the metal handle.
4. Close the jar with the lid and the measuring cap.
5. Set the desired time by pressing the TIME button and then the + or – buttons. The value will
be displayed on the control screen.
6. Set the desired cooking temperature by pressing the TEMP button and then the + or – buttons.
The value will be displayed on the control screen.
7. Select the speed level by pressing the SPEED button and then the + or – buttons. The value
will be displayed on the control screen.
8. Press the Start button
9. Once the program has finished, an acoustic signal will be heard.
. The appliance will start its program.
English
EN
11