Publicidad
Idiomas disponibles
Idiomas disponibles
AC PARALLEL OPERATION
Before connecting an appliance to either generator, make sure that the appliance is
in good working order and that its electrical rating does not exceed that of the
receptacle.
Most motorized appliances require more than their electrical rating for startup.
When an electric motor is started, the overload indicator (yellow) may come on.
This is normal if the overload indicator (red) goes off within 9 seconds. If the
overload indicator (red) stays on, consult your generator dealer.
During parallel operation, the Eco-Throttle switch should be in the same position
on both generators.
1.
Connect the parallel operation cable kit between the two AY3000i
generators following the instructions supplied with the kit.
. 2
Start the engines and make sure the output indicator
comes on.
3.
Plug in the appliance following the instruction provided with the parallel operation
cable kit.
4.
Turn on the appliance.
If the generators are overloaded , or if there is a short circuit in a connected
appliance, the overload indicator (yellow) will come on.
on the LCD screen over 1.3 times of the rated current, the generator will cut off
output in 3 seconds,
output indicator (green) will go off. Stop both
current to the connected
PARALLEL OPERATION
CABLE KIT
(optional equipment)
(green) on each generator
When the current displayed
appliance(s) will shut off, and the
engines and investigate
24
the problem.
Publicidad
