Descargar Imprimir esta página

Progress Lighting Paso P250109 Serie Manual De Instalación página 12

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

Remote Control Button Definitions: (Fig. 16)
These six buttons are used to set the fan speed as
follows:
1 = minimum speed
2 = low speed
3 = medium low speed
4 = medium speed
5 = medium high speed
6 = high speed
button: Turns the fan off.
button: Controls fan direction.
Your DC brushless motor is equipped with an
automatically learned type remote control. There are
no frequency switches on the receiver; the receiver
unit will automatically scan the frequency from the
remote control if any changes are made. The
frequency settings on the transmitter should be
changed ONLY in case of interference or if a
second or more ceiling fans with the same type of
control system are installed in the same structure.
Setting the Remote Control
Follow the below steps to set the remote control:
The auto learning function will only mandate within
60 seconds when turning the fan's AC power ON.
9. Operating Your Transmitter
From the back of the transmitter, with the fan's
power off, restore power to the fan. Press and
hold "SET" button for about 5 seconds and
release. If optional light kit is installed, the light
kit will flash twice and the signal light on the
hand held transmitter will come on when the
button is pressed. The fan has completed the
pairing process with the remote control and is
ready for use. (Fig. 17)
NOTE: If the self calibration test failed, turn the
AC power off; restore power and process the self
calibration test again.
NOTE: During self calibration test, the remote
is non-fuctional.
NOTE: The learning frequency function and self
calibration test will continue to retain the last set
frequency and calibration set even when the AC
power is shut off. If the frequency is changed the
self calibration test will occur again.
Over 80W protection: When the receiver detects
motor power consumption which is greater than
80W, the receiver power will be stopped and
operation will immediately discontinue. Wait for
5 seconds and then turn the receiver power back
on.
Figure 16
Figure 17

Publicidad

loading

Este manual también es adecuado para:

Paso p250109-031Paso p250109-163Paso p250109-31m