Publicidad
Idiomas disponibles
Idiomas disponibles
A
Using the appliance
inside chimney bracket
5. Install the v-flap, converter and expansion pipe onto the cooker hood. Fix the expansion
pipe on the outlet with a cable tie. See Pic 3. Note: the expansion pipe not included in the
product.
expension pipe
converter
v-flap
6. Put the hood hang on the wall in the fixed position, adjusting the cooker hood position,
fix the cooker hood with 2pcs ST4*30mm safety screws. Note: The two safety vents are
positioned on the back housing, with a diameter of 6mm. See Pic 4 & 6.
st4*40mm screws
mounting screws
safety screws
Pic 2
Cable tie
Pic 3
Pic 4
6
EN
A
Using the appliance
7. Install the outside chimney bracket onto the outside chimney with 2 pcs ST4*8mm screws,
make sure the inside chimney can be flexed freely. See Pic 5. And then put the chimney
to the hood, use 2 pcs ST4*8mm screws fix the outside chimney to the hood body and the
use 2pcs ST4*40mm fix it on the wall. Lay the expansion pipe to the outside at the same
time. See Pic 6.
inside chimney
outside chimney bracket
outside chimney
Pic 5
8. Adjust the height of the inside chimney to the position of the inside chimney bracket and
fix it with 2pcs ST4*8mm screws. See Pic 7.
Pic 6
Pic 7
7
EN
Publicidad
