Publicidad
Idiomas disponibles
Idiomas disponibles
B
Useful information
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy
water. Ensure the cloth is clean and well wrung before
cleaning. Use a dry soft cloth to remove any excess moisture
left after cleaning.
IMPORTANT:
Using neutral detergents and avoid using harsh cleaning
chemicals, strong household detergents or products
containing abrasives, as this will affect the appearance of
the appliance and potentially remove any printing of artwork
on the control panel and will void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for
about 3 minutes in water with a mild detergent and then
brush it gently with a soft brush. Do not apply too much
pressure so as to avoid any damage to it. (Leave to dry
naturally out of direct sun light.)
Filters should be washed separately to crockery and kitchen
utensils. It is advisable not to use rinse aid.
Following the picture beside to dismantle the grease filter.
14
EN
B
Useful information
INSTALLING GREASE MESH FILTERS
To install filters for the following four steps:
• Angle the filter into the slots at the back of the hood.
• Push the button on the handle of the filter.
• Release the handle once the filter fits into a resting
position.
• Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally
the activated carbon filter should be changed every 3 to 6
months according to your cooking habits. The installation
procedure of the activated carbon filters is as below:
1. Before installing or replacing the carbon filters,
disconnect the mains power to the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both sides of the motor anti-
clockwise. Replace the carbon filters with the new
carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
15
Open
Close
EN
Publicidad
