Comet MTP LW-K 250 Instrucciones Para El Ensamblaje -Uso Y Mantenimiento página 30

- pumping of water at high pressure in washing machines (high pressure cleaners);
- pumping water for non-edible use.
• The motor pump must not be integrated in machines for pumping:
- unfiltered water or with impurities;
- detergents, paints and chemical substances, both pure and in aqueous solution;
- seawater or water with high salt concentration;
- fuels and lubricants of all kinds and types;
- inflammable liquids or liquefied gases;
- edible liquids;
- solvents and thinners of all kinds and types;
- paints of all kinds and types;
- water with temperatures above 60 °C/140 °F (50 °C/122 °F for MTP KTR, MTP KTR Misting, MTP KMR,
MTP KSR, MTP KSR Misting) or below 5 °C/41 °F;
- liquids containing granules or solid parts in suspension.
• The motor pump must not be integrated in machines designed to wash: people, animals, energized electrical
apparatus, delicate objects, the motor pump itself or the machine in which it is integrated.
• The motor pump is not suitable for being integrated in machines designed to operate in environments with
special conditions such as, for example, corrosive or explosive atmospheres.
• For integration in machines designed to operate on board vehicles, ships or planes, contact the Manufacturer's
Technical After-Sales Service, inasmuch as additional requirements may be necessary.
All other uses are to be deemed incorrect.
The Manufacturer disclaims all liability for any damage deriving from incorrect or erroneous uses.
WARNING
• The motor pump cannot be operated unless the machine in which it is integrated conforms to the
safety requirements laid down by European directives. Such conformity is indicated by
and by the declaration of conformity of the Manufacturer of the machine in which the motor pump is
integrated.
• Also follow the instructions contained in the use and maintenance manual of the machine in which
the motor pump is integrated.
• Make sure all deliveries are off or connected to accessories that have been turned off (e.g., closed spray gun).
• Make sure that the moving parts of the motor pump are suitably protected and that they are not accessible to
unauthorised persons.
• Do not use the motor pump (and therefore the machine in which it is integrated) in the event of:
- the supply cable or other important parts such as the high-pressure pipes and the safety devices being damaged;
- its having suffered heavy knocks;
- evident oil leaks;
- evident leaks of pumped liquid.
In such cases, have the motor pump and the machine in which it is integrated checked by a Skilled Technician.
• Have a Skilled Technician perform the inspections required by special maintenance.
• Wear clothing and personal protective equipment able to provide adequate protection from any high-pressure
jets and chemical products used.
Carry out the preliminary activities indicated in the manual of the machine in which the motor pump is
integrated; unless otherwise indicated, with respect to the motor pump, always remember the following.
a) Replace the oil cap without vent (8) with the oil cap with vent (9) (see Fig. 15). This operation could already
have been performed by the Manufacturer of the machine in which the motor pump is integrated.
b) With the engine off and the motor pump completely cooled down, make sure the oil level is at mid-point of
the oil level indicator (7).
For any touch ups, refer to the types of lubricants indicated in the paragraph
" .
DATA
30
PRELIMINARY ACTIVITIES
markings
"S
PECIFICATIONS AND TEChNICAL