Comet MTP LW-K 250 Instrucciones Para El Ensamblaje -Uso Y Mantenimiento página 35

WARNING
• Once the motor pump and the machine in which it is integrated have cooled down, be careful:
- not to leave them unattended in the presence of children, elderly people or disabled persons without supervision;
- to arrange them in a stable position without any risk of falling;
- not to put them in contact or in the immediate vicinity of inflammable materials.
WARNING
• WARNING. All cleaning jobs must only be performed after carrying out the operations described in the
"s " paragraph, meaning without any moving parts, no pipe full of liquid under pressure and only
top
after complete cooling.
In particular, always remember to disconnect the power supply.
• Any cleaning jobs must be performed in conditions of total stability.
• To clean, do not use thinners or solvents.
CAUTION
• The motor pump must be protected against freezing.
In very cold environments, to prevent the ice from forming inside, before decommissioning, it is best to
suction a car anti-freeze product (after contacting a Skilled Technician inasmuch as the liquid could damage
the high-pressure pump seals) and then proceed to fully expel it. If it is not possible to protect the motor
pump this way, before starting it, take it to a warm environment for long enough to melt any ice inside.
Failure to do so could cause serious damage to the motor pump.
WARNING
• The antifreeze liquid must be suitably disposed of and not discarded in the environment.
NOTE .
After a prolonged stop, slight water dripping could occur underneath the motor pump. Such dripping normally
disappears after a few hours of operation. Should it persist, contact a Skilled Technician.
WARNING
• Follow the maintenance instructions contained in the manual of the machine in which the motor pump
is integrated.
• All maintenance jobs must only be performed after carrying out the operations described in the
paragraph, meaning without any moving parts, no pipe full of liquid under pressure and only after
complete cooling.
In particular, always remember to disconnect the power supply.
• Any maintenance jobs must be performed in conditions of total stability.
• WARNING. To ensure the safety of the motor pump, only use original spare parts supplied by the Manufacturer
or approved by it.
CLEANING AND DECOMMISSIONING
MAINTENANCE
EN
"s "
top
35