Publicidad
Idiomas disponibles
Idiomas disponibles
5. PANELS MOUNTING
EN
5.10 Optional 1/8'' panel reveal for multiple unit installation
Note: when joinig multiple using overlay panels as per the instructions herein for single install, the
resulting gap/reveal will be 3/16" between panels. If you would like to maintain ~1/8" reveal between
all the panel and gables you can add 1/16" to the width dimension of the specified panel for each unit.
For example: joining a 24"+30"+36" unit:
Opening width: 24"+30"+36"=90"
Standard panel widths based on single unit installs: 23-3/4"+29-3/4"+35-3/4"=89-1/4"
This leaves an overall space of 3/4" divided by 4 gaps= 3/16"
If you add 1/16" to each panel: 23-13/16"+29-13/16"+35-13/16"=89-7/16"
This would result in an overall space of 9/16" divided by 4 gaps = 9/64" (~1/8") betweeen panels
30
6. INSTALLATION: BOTTOM COMPRESSOR MODELS
IMPORTANT: The following instruction for installation apply to all Fulgor Milano models.
6.1 Built-in installation of
single appliance
For a built-in installation, to cover gaps between
the appliance and the adjacent cabinets and affix
the appliance to the cabinetry, use the supplied
10 x piece bracket kit. Follow the instructions
included in the bag with the brackets for
placement of brackets on the appliance.
Operate as follows:
>
Push the appliance into the installation cutout
[ 1
1
>
Always mount front panel on door before
pushing the unit into its final position inside the
cutout or structure.
>
Check the levelling of the appliance, adjusting
its feet and wheels to correct it.
>
Secure the appliance to the adjacent cabinets
using the 10 x spacer brackets.
[ 2
].
Door must be open to access the brackets. Screws
for fixing the brackets to adjacent cabinetry are
not included.
2
>
Mount the bracket covers: first insert them
laterally and then push firmly until a "click" is
heard
[ 3
].
3
].
Side profiles mounting:
(Bird's eye view)
Appliance
A
Click!
Click!
B
B
Wall or furniture
A Plastic connecting brackets
B Profile trim cover
6.2 Built-in installation of two or more
appliances
>
The central profile is provide with freezer and
wine cellar columns.
Plastic covering frames are provided for
closing gaps between the appliance and the
adjacent cabinets.
Operate as follows:
>
Position the appliances in front of the installation
area, leaving enugh space to operate at their back
[ 1
].
EN
31
Publicidad
