Publicidad
Idiomas disponibles
Idiomas disponibles
6. INSTALLATION: BOTTOM COMPRESSOR MODELS
EN
Distance between units (A+B)
C
18" model
18" model
7/8" (22 mm)
15/16" (23.5 mm)
24" model
15/16" (23.5 mm)
B
30" model
1" (24.5 mm)
36" model
1" (25.5 mm)
1 1/16" (27 mm)
Once the appliances have been adjusted and properly levelled, loosen the two screws holding the sealing
plate in position.
Lower the plate until flush with the floor, and re-tighten the screws. This will ensure optimized airflow through
the condenser necessary for proper operation.
This table is a reference for what the space at the back of the units should be between the appliance bodies
when installing the metal brackets from the joining kit. This space between the bodies will occur naturally
when connecting the units at the front using the supplied plastic mounting brackets. The table is a tool to
allow you to ensure that the space between the units is consistent from front to back. Example of why this is
important: if the space at the back between the units is wider than the space at the front, when opening the
drawers they may collide with each other when fully extended.
>
Next join them at the front attaching the plastic
connecting brackets with the supplied screws
It is suggested to use two screws for connecting
each bracket; one from each side
[ 4
].
34
A
24" model
30" model
36" model
1" (24.5 mm)
1" (25.5 mm)
1" (25 mm)
1" (26 mm)
1 1/16" (27 mm)
1" (26 mm)
1 1/16" (27 mm)
1 1/8" (28 mm)
1 1/8" (28 mm)
1 1/8" (29 mm)
3
[ 3
].
>
Finish off by mounting the central profile cover
onto the central brackets, by pushing it until a click
is heard
[ 5
].
5
>
Once completed, push the units into their final
[ 6
].
position
Always mount front panels on door before pushing
the unit into its final position inside the cutout or
structure.
>
Check the levelling of the appliance, adjusting its
feet and wheels to correct it.
>
Secure the appliance to the adjacent cabinets by
fixing with the supplied brackets on the appliance
7
]. The door must be open to access the brackets
for attachment to the cabinetry.
6
4
>
Mount the covering frames onto the brackets
used to join the units, first insert them laterally and
then push firmly until a "click" is heard
[ 8
7
8
7
8
Take care as appliances will be front-
heavy and may tip before they are secured
to the adjacent furniture.
[
EN
].
35
Publicidad
