DM 2610031482 05-13_MM30 5/28/13 8:11 AM Page 8
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting the
tool accidentally.
For all work or when
W RNING
changing
always wear protective gloves. Such
preventive safety measures reduce the risk of
injury from sharp edges of the accessories.
Application tools can become very hot while
working. Danger of burns!
INSTALLING AND REMOVING
ACCESSORIES WITH qUICK-RELEASE
ACCESSORy CHANGE
The Dremel Multi-Max MM30 includes an
integrated wrench system which allows users
to quickly and easily change accessories.
1. Push down on wrench release button
(blue) and push wrench forward to release
wrench. Pivot out the socket head (Fig. 2).
2. Loosen the clamping screw just enough so
you can slide the accessory between the
accessory holder and washer (Fig. 3).
3. Clean the accessory holder, accessory,
and clamping screw with a clean cloth.
4. Place the accessory onto the accessory
holder, making sure the accessory
engages all pins in the holder and the
accessory is flush against the accessory
holder.
5. Securely tighten the clamping screw with
the Quick-Release wrench (Fig. 4) and
place it back onto the tool. The wrench
should snap back onto the tool.
NOTE: Some accessories, such as scrapers or
blades, may be mounted either straight on the
tool, or at an angle to enhance usability (Fig. 5).
FIG. 5
Assembly
FIG. 2
accessories
FIG. 3
ccessory
ccessory
FIG. 4
-8-
1
2
3
ccessory
Holder
Blade
Washer
Quick Release
Wrench
Clamping
Screw
Clamping
Screw
Quick
Release
Wrench