Descargar Imprimir esta página

Husky 32220 Instrucciones De Ensamblaje página 4

Ocultar thumbs Ver también para 32220:

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Prior to assembly of "HUSKY ROLLER", be sure that your base rails are properly installed and
square with each other. Measure diagonally across the rails. See Figure 1. Measurements "X" &
"Y" should be within 3/16" of each other. These measurements are required for proper fit and
function of the "HUSKY ROLLER". If using pre-existing base rails, ensure that the center to center
(fore and aft) distance is 22" and that there are two pairs of slots in the base rails that are 20-5/8""
apart (side to side) Otherwise contact your local dealer for proper base rail selection and installation.
2. Install the included Husky Center Bolt kit, which is REQUIRED.
3. Locate the center hole in each base rail. See Figure 1. Using these holes as a guide, drill a 5/8"
hole through the truck bed. Confirm that the fuel tank, brake/fuel lines, electrical wires
located under the bed are not in the path of drilling the holes in this step.
4. Drop the 5/8 carriage bolts supplied through the center bolt locations, through the truck bed.
5. Check the corrugations in the truck bed floor and place the spacer plate in the correct position
as shown. See Figure 2.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information /
Tech Support / Product Updates. 2020 Keystone Automotive Operations Inc. All Rights Reserved. 08/27/2020-Rev8
CENTER BOLT INSTALLATION
Base Rails Not Included
Page-4

Publicidad

loading