Publicidad
Idiomas disponibles
Idiomas disponibles
8. Install the base rail pins and hair pins. The base rail pin MUST point AWAY from ALL the anti-
lift screws on both roller assemblies or the hitch will not slide properly. See Figure 8
Figure 8
9. Install cross member and ensure it is centered and straight by shimming (if necessary) and then
torque bolts to 75 ft. lbs. Note: The roller housing assemblies need to be parallel within 1/4".
Multiple shims or 1/2" washers can be stacked together if gap width is large. See Figure 11
10. Tighten 3/8" nut and bolt to 30 ft.-lbs. The tubes on the Handle and Long Tube should crush
slightly. This will insure a tight fit. The handle and long tube assemblies should and all move and
rotate as one.
11. Pull handle out and rotate so that both latching pins rotate and lock into hole # 3. See Figure 4.
Push the Husky Roller rearward until the latching pins insert completely into hole #4. See Figure
4.
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information /
Tech Support / Product Updates. 2020 Keystone Automotive Operations Inc. All Rights Reserved. 08/27/2020-Rev8
Base Rail Pin
Anti-lift Screw
VIEW FROM UNDER THE HOUSING ASSEMBLY
Rear of Truck
Hair Pin
Page-8
Publicidad
