PRESIDENT BILL FCC Manual Del Usuario página 11

ALERT
(long press)
The SIREN tone only sounds in
WX
in mode.
Long press the ALERT key (7), in order to
vate the ALERT function. When the function is activated
and a tone is detected at the selected weather channel,
then the unit sounds SIREN tone. The unit cancel
WX
and go to mode.
During a SIREN tone sound, press PTT key (11) to stop the
sound.
8) EMG ~ EMG SETTING
EMG
(short press)
Emergency channel is automatically selected when
by pressing EMG Key (8). First short press to
emergency customisable channel (or the default channel
9). "EMG1" appears on the display. Second short press to
call the second emergency customisable channel (or the
default channel 19). "EMG 2" appears on the display. Third
short press to go back to the current channel. "EMG..."
disappears on the display.
EMG SETTING
(long press)
Priority channels can be assigned to any channel. To
define a new priority channel:
1. Press shortly the EMG key (8) to select the priority channel
to be customized. "EMG1" or "EMG 2" should be displayed
on the LCD.
2. Press the EMG key (8) for one second to
channel. EMG-ST is displayed. "EMG1" or "EMG 2" blinks.
CB
mode. It does not sound
activate/deacti-
CB
mode
call
the first
set
the selected
3. Use s/t key (3) on the unit or UP/DN key (3) on the
microphone to select
priority channel selected at the point 1.
4. Press shortly the EMG key (8)briefly to
CB
The unit returns to
5. If no key is pressed for 10 seconds, the unit automatically
exits the setting function to return to
The default priority channels are channel 9 (EMG1) and
channel 19 (EMG2) respectively.
9) USB CHARGING SOCKET
The USB socket (9) can be used to
tablet or other rechargeable device with 5 V - 2.1 A.
10) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver
and makes the setting of the equipment into the dash-
board easier. The BILL FCC accepts electret or dynamic
microphone (see menu MIC TYPE on page 12).
See cabling diagram page 60.
11) PTT (Push To Talk)
Transmission key, press PTT switch to transmit a message,
is displayed and release to listen to an incoming
communication.
TOT (Time Out Timer)
If the PTT switch (11) key is pressed for more than 3 minutes,
the display starts blinking and the transmission ends.
A beep will sound until the PTT switch (11) key is released.
11
the new channel to assign to the
confirm
your choice.
mode.
CB
mode.
charge
a smartphone,