Assembly - Delta 36-R31 Manual De Instrucciones

1
2
1. Unisaw
2. Switch (shown with a magnetic starter)
2A. Motor Cover
3. Extension wing (2)
4. Handwheel
5. Blade guard and splitter assembly
6. Upper bracket for splitter
7. Lower bracket for support rod
8. Support rod
9. 7/8" Open end arbor wrench
10. 7/8"x1/2" Closed end arbor wrench
11. Dust chute
12. Miter gauge
13. Cap for miter gauge handle
14. Handle for miter gauge
15. Handwheel lock knob
16. 1/8" Hex wrench
17. 5/64" Hex wrench
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
2A

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
1/8" Hex wrench (supplied)
5/64" Hex wrench (supplied)
7/8" Open end arbor wrench (supplied)
7/8"x1/2" Closed end arbor wrench (supplied)
Various other open-end wrenches or a socket set (not supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately two to three hours.
4
3
16
11
15
19
24
20
25
21
26
22
23
27
18. Hanger for rip fence (2)
19. 7/16-20x1¼" Hex head screw (6)
20. 5/16-18x1" Hex head screw (4)
21. 5/16-18x1" Flat Head Screw (1)
22. #10x1/2" Hex washer head screw (8)
23. 10-32x1/2" Pan head screw (2) (use w/ LVC starters)
24. 3/4" I.D. Fiber washer (1)
25. 5/8" I.D. Internal tooth washer (1)
26. 7/16" I.D. Flat washer (6)
27. 5/16" I.D. Flat washer (2)
28. 5/16" I.D. Flat washer (1) (use w/ magnetic starters)
29. 5/16" I.D. Lockwasher (3)
30. 1/4" I.D. Fiber washer (1)
31. 13/64" I.D. Flat washer (2) (use w/ LVC starters)
32. 5/8-18 Jam nut (1)
33. 5/16-18 Hex nut (1) (use w/ magnetic starters)
34. 1-3/8" Key (1)
35. Spring clip (2) (use w/ LVC starters)
8
6 7 8
5
10
12
17 13 14
18
28
32
33
29
34
30
35
31
9