Publicidad
Idiomas disponibles
Idiomas disponibles
1
Film ejection slot
The exposed INSTAX MINI instant film will be ejected from
the film ejection slot during printing.
2
Flash
The flash operates depending on the setting. You can also
set the flash to not operate.
3
Self timer lamp/Charging lamp
The self timer lamp/charging lamp blinks when you take a
photo with the self-timer. Also, it lights up during charging
and turns off when charging is complete.
4
Shutter button
Press the shutter button halfway to focus on the subject.
Then press it fully to operate the camera shutter and take a
photo. Press the shutter button in playback mode to switch
to shooting mode.
5
Selfie mirror
Use the selfie mirror to check your framing before taking
a selfie.
6
Lens
This is the lens used to take photos. Make sure that your
fingers do not obstruct the lens during shooting.
7
Tripod hole
You can attach a tripod by using this hole.
8
Power switch
Turn the power switch clockwise to turn on the power. Turn
it counter-clockwise to turn off the power.
BO-38_QM_NA.indb 5
9
*1
Reset button
If the camera is not operating properly, press this button
to force the camera to turn off. After pressing the reset
button, turn the power switch off and then on again to
start the camera. Do not use the reset button while the
camera is operating normally. Doing so may cause the
photo data to be erased.
10
USB Type-C port
This is the USB port for charging the camera. The USB port
cannot be used for data transfer.
11
Micro SD card slot
This is the slot for a micro SD card.
12
Lens dial
Turn the lens dial to switch between 10 different lens
effects.
13
Strap hook
Pass the cord on the strap through the strap hook to attach
the strap.
14
Film door lock
Slide the film door lock to the right to unlock the film door
so that it can open.
*1 If the camera is not working properly, press the reset button
to reset it.
EN
5
1/6/2023 12:34:35 PM
Publicidad
