Flex LD 18-7 125 R Instrucciones De Funcionamiento Originales página 22

Switching the electric power tool on
and off
Brief operation without engaged switch
rocker
First press the starting lockout.

Then press and hold down the switch.
Release switch interlock.
To switch off, release the switch.

Continuous operation with engaged switch
rocker
First press and hold down the starting

lockout and then the switch.
To lock into position, hold down the

locking button and release the switch.
Release switch interlock.
NOTE
Following a power failure, the switched on
power tool does not restart.
22
LD 18-7 125 R/LD 18-7 150 R
Switch off the machine
To switch off, briefly press and release

the switch.
Working with the power tool
WARNING!
The rotating sanding disc must not come
into contact with sharp projecting objects.
Danger of kickback! Damage to sanding
pad. If the sanding pad is damaged or
severely worn, it must be replaced.
CAUTION!
Hold the electric power tool with both hands!
1. Attach sanding tool.
2. Connect dust extraction system.
3. Insert mains plug.
4. Switch on dust extraction system.
5. Switch on the device.
6. Place the renovation sander on the
work surface. The brush ring must be
flush with the work surface.
7. Increase the pressure to bring the
sanding pad into contact with the work
surface. In doing so, slew the
renovation sander with overlapping
movements.