Flex LD 18-7 125 R Instrucciones De Funcionamiento Originales página 237

LD 18-7 125 R/LD 18-7 150 R
Safety instructions
t^okfkd>
oÉ~Ç=~ää=ë~ÑÉíó=áåëíêìÅíáçåë=~åÇ=çíÜÉê=
áåëíêìÅíáçåëK=c~áäìêÉ=íç=çÄëÉêîÉ=íÜÉ=ë~ÑÉíó=
áåëíêìÅíáçåë=~åÇ=çíÜÉê=áåëíêìÅíáçåë=ã~ó=êÉëìäí=
áå=~å=ÉäÉÅíêáÅ=ëÜçÅâI=ÑáêÉ=~åÇLçê=ëÉêáçìë=
áåàìêáÉëK=hÉÉé=~ää=ë~ÑÉíó=áåëíêìÅíáçåë=~åÇ=
çíÜÉê=áåëíêìÅíáçåë=áå=~=ë~ÑÉ=éä~ÅÉ=Ñçê=íÜÉ=
ÑìíìêÉK
 This electric power tool must be used
as a sander. Read all safety warnings,
instructions, illustrations and speci-
fications provided with this power tool.
Failure to follow all instructions listed
below may result in electric shock,
fire and/or serious injury.
 Operations such as sanding, wire
brushing, or for polishing and cut-off
are not recommended to be performed
with this power tool.
Operations for which the power tool was
not designed may create a hazard and
cause personal injury.
 Do not use accessories which are not
specifically designed and recommen-
ded by the tool manufacturer.
Just because the accessory can be
attached to your power tool, it does
not assure safe operation.
 The rated speed of the accessory must
be at least equal to the maximum
speed marked on the power tool.
Accessories running faster than their rated
speed can break and fly apart.
 The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly measured insertion tools
cannot be adequately shielded or con-
trolled.
 Sanding discs, sanding pads or other
accessories must fit exactly on
the grinding spindle of your electric
power tool.
Insertion tools, which do not fit exactly
on the grinding spindle of the electric
power tool, rotate unevenly, vibrate
violently and may result in loss of control.
 Do not use a damaged accessory.
Before use, always check insertion
tools for splinters and cracks, sanding
pad for cracks, wear and severe
abrasion. If power tool or accessory
is dropped, inspect for damage
or install an undamaged accessory.
After inspecting and installing an
accessory, position yourself and
bystanders away from the plane
of the rotating accessory and run
the power tool at maximum no-load
speed for one minute.
Damaged accessories will normally break
apart during this test time.
 Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety
glasses. If appropriate, wear a dust
mask, hearing protection, protective
gloves and/or a special apron which
protect you from small sanding and
material particles.
The eye protection must be capable
of stopping flying debris generated by
various operations. The dust mask or
respirator must be capable of filtrating
particles generated by your operation.
Prolonged exposure to high intensity
noise may cause hearing loss.
15