Flex LD 18-7 125 R Instrucciones De Funcionamiento Originales página 243

LD 18-7 125 R/LD 18-7 150 R
 Check position of the guard.
The brush ring should protrude over
the sanding pad by approx. 0–1 mm.
If required, correct (see "Adjusting the
guard").
 Insert the mains plug into the socket.
 Switch on the electric power tool (without
locking the button) and leave it running
for approx. 30 seconds.
Check for imbalances and vibrations.
 Switch off the electric power tool.
Adjusting the guard
klqb
The brush ring should protrude over the sanding
pad by approx. 0–1 mm. To compensate for
wear on the diamond sanding pad, the height
of the guard can be adjusted.
 Loosen clamping lever on guard hood.
 Set the guard hood to the required height.
 Tighten the clamping lever.
klqb
fÑ=íÜÉ=Åä~ãéáåÖ=ÑçêÅÉ=ÇÉÅêÉ~ëÉëI=íÜÉ=Åä~ãéáåÖ=
Å~å=ÄÉ=~ÇàìëíÉÇ=Äó=íáÖÜíÉåáåÖ=íÜÉ=ÜÉñ~Öçå=
ëçÅâÉí=ëÅêÉï=çå=íÜÉ=Åä~ãéáåÖ=äÉîÉêK
Connecting an extraction system
klqb
It is recommended to use a FLEX Class M
dust extractor.
 Attach extraction hose to the connector
on the guard hood.
 Attach power cord to the extraction hose
using the enclosed cable holders (3x).
 Connect extraction hose to the dust
extraction system. Follow the operating
instructions for the dust extraction system!
Check the attachment! If required, use an
appropriate adapter.
klqb
fÑ=óçìê=Çìëí=Éñíê~Åíçê=êÉèìáêÉë=~=ëéÉÅá~ä=
ÅçååÉÅíáçå=EáKÉK=~=ÅçååÉÅíáçå=çíÜÉê=íÜ~å=
íÜÉ PO=ããLPS=ãã=ëí~åÇ~êÇ=ÅçååÉÅíáçå=
ïÜáÅÜ=áë=áåÅäìÇÉÇ=ïáíÜ=íÜÉ=ÉäÉÅíêáÅ=éçïÉê=
íççäFI=Åçåí~Åí=óçìê=Çìëí=Éñíê~Åíçê=ëìééäáÉê=
íç çÄí~áå=íÜÉ=~ééêçéêá~íÉ=~Ç~éíÉêK
21