Flex LD 18-7 125 R Instrucciones De Funcionamiento Originales página 245

LD 18-7 125 R/LD 18-7 150 R
7. Increase the pressure to bring the
sanding pad into contact with the work
surface. In doing so, slew the renovation
sander with overlapping movements.
8. Sanding in corners:
– Switch off the power tool and wait
until the sanding tool has come
to a standstill.
– Pull out pivoted edge segment and
swivel to left.
– Switch on power tool again.
9. After work, switch off the electric power
tool and pull out the mains plug.
Brush ring
The guard features a brush ring. This ring has
two functions:
– As the ring projects above the surface
of the sanding pad, it is the ring which
comes into contact with the work sur-
face first. As a result, the sanding pad
is brought parallel to the work surface
before the sanding tool comes into
contact with the work surface.
This avoids a sickle-shaped depression
caused by the edge of the sanding pad.
– The ring retains the dust until it is extracted
by the dust extractor.
If the brush ring is damaged or excessively
worn, it should be replaced.
A replacement brush set is available from
any FLEX customer service centre.
Maintenance and care
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK=
Cleaning
t^okfkd>
aç=åçí=ìëÉ=ï~íÉê=çê=äáèìáÇ=ÇÉíÉêÖÉåíëK
 Regularly blow out the housing interior
and motor with dry compressed air.
 Clean the guard and pivoted edge
segment using dry compressed air.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
klqb
aìêáåÖ=íÜÉ=ï~êê~åíó=éÉêáçÇ=Çç=åçí=äççëÉå=
íÜÉ ëÅêÉïë=çå=íÜÉ=ãçíçê=ÜçìëáåÖK=
kçåJÅçãéäá~åÅÉ=ïáää=ÇÉÉã=íÜÉ=Öì~ê~åíÉÉ=
çÄäáÖ~íáçåë=çÑ=íÜÉ=ã~åìÑ~ÅíìêÉê=åìää=~åÇ=îçáÇK
Spare parts and accessories
Other accessories, in particular insertion
tools, can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
23