Emptying The Dirt Cup - Hoover Z 700 Manual De Uso

Emptying the dirt cup

Dirt cup
Your cleaner is equipped with a self-cleaning HEPA filter.
18
This filter is NOT removable.
While the cleaner is in operation, the pre-filter screen (A) will stop larger
debris from entering the HEPA filter chamber. This larger debris will be
seen collecting in the larger side of the dirt cup (B). The HEPA filter will
collect fine particles that have passed through the pre-filter screen. The
HEPA filter cleans itself while rotating, depositing fine debris in the smaller
side of the dirt cup (C).
The 'Z' cleaner will continue to perform at maximum cleaning levels if the
pre-filter screen is cleaned when the dirt cup is emptied (see Fig. 21).
If you notice that the filter is rotating slower than normal, not rotating, or
the filter light comes on, refer to the Troubleshooting section.
When to empty
It is recommended that the dirt cup be emptied before the dirt reaches the
top of the dirt cup or after every use if you prefer.
How to empty
Disconnect cleaner from electrical outlet. Do not use cleaner without dirt
cup or filters in place.
Unfold the cleaner to the upright position before removing dirt cup.
To remove cup, pull handle to unlatch cup. Pull cup straight out.
19
Turn the dirt cup upside down over a trash container. Pull tab to
20
release door (D). Empty dirt cup.
CLEAN THE PRE-FILTER SCREEN (E) using the dusting brush tool.
21
Push the cup straight into the dirt cup cavity, push up slightly and
22
pivot the handle back to lock the dirt cup in place.
C
D
(Cont'd)
A
B
E
11