Hoover Z 700 Manual De Uso página 13

Check behind access door
26 5. Turn cleaner OFF and disconnect from electrical outlet. Remove
access door (A); check for blockage. Replace access door.
Check airflow path
6. Remove hose from wand.
7. Plug cleaner in and turn ON. Check for suction at end of hose. If
27
there is suction, continue with step 9. If there is no suction, check for
blockage in hose. Clear blockage.
8. Turn cleaner OFF and disconnect from electrical outlet.
9. Lower handle to floor. Remove 2 screws, one on each side of the
28
hose. Check for blockage in hose. Clear blockage.
Check wand
10. Turn cleaner OFF and disconnect from electrical outlet.
11. Remove wand from cleaner. Check for blockage. Clear blockage.
29
Check powered hand tool
1. Disconnect powered hand tool from hose. Remove bottom
30
plate, belt guard and turbine as described in Figs. 31, 32 and 37.
Remove any blockage from turbine channel (A).
Replace belt turbine, brush roll, belt guard and bottom plate.
A
A
(Cont'd)
13